User guide · AEGIS-C
Setup and connection from the JAVI PEEL user manual. Peel the foot films first, pick a link mode, then tune DPI and polling as needed.
1. Before first use
- Peel the protective film from all mouse feet: front feet, rear feet, and the sensor ring.
- Leftover film can affect glide and tracking — finish this before the first session.
2. Controls map
- 1Left button
- 2Right button
- 3Scroll wheel / middle button
- 4Forward button
- 5Back button
- 6DPI button
- 7Mode switch (top: 2.4G · middle: OFF / wired · bottom: BT)
- 82.4G receiver storage compartment
3. Wired connection
- Set the mode switch (7) to the middle (OFF) position.
- Connect the mouse to the computer with the USB-C cable.
- When plugged into a host USB port, the mouse runs in USB wired mode with priority.
4. 2.4G wireless
- Set the mode switch to the top position (2.4G).
- Hold Left + Right + Scroll for 3 seconds until the green LED flashes.
- Remove the receiver from the bay and insert it within 30 seconds; a solid green LED confirms pairing.
- If the receiver is not inserted within 30 seconds, the green LED stops flashing and pairing ends.
5. Bluetooth
- Set the mode switch to the bottom position (BT).
- Hold Left + Right + Scroll for 3 seconds until the blue LED flashes to start pairing.
- In your OS Bluetooth settings, select and connect AEGIS-C.
6. DPI
Press the DPI button to cycle levels. Indicator color matches the active level (PEEL user manual):
| Indicator | DPI |
|---|---|
| Red | 400 |
| Green | 800 |
| Blue | 1600 |
| Yellow | 3200 |
| Cyan | 6400 |
| Purple | 12000 |
Note: CGS Control Center can rewrite DPI values. This guide lists factory PEEL steps (store labels may show 800 / 1200 / 1600 / 2400 / 5000 / 12,000).
7. Polling rate
- Change polling rate in CGS Control Center.
- Default polling rate: 1000 Hz.
- Bluetooth does not support 1000 Hz — use USB-C or 2.4G when you need 1K.
8. Indicators
- Green flashing: 2.4G pairing active; solid green confirms success.
- Blue flashing: Bluetooth pairing active.
- Red flashes 3 times every 5 minutes: battery below 3.6 V (low-battery alert).
9. Driver download
Download CGS Control Center: cerogamingstudio.com/pages/downloads
Quick tip: Wired USB takes priority when connected. Before wireless use, confirm the underside switch position, then run pairing or Bluetooth connect.